Typical Enabling Conditions
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| Monitor runs whenever following DTCs are not present | None |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| Time after starter OFF to ON | 3 seconds or more |
| Battery voltage | 7 V or higher |
| Minimum battery voltage while starter ON | Less than 11 V |
| Camshaft position sensor circuit fail (P0340, P0342, P0343) | Not detected |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Engine speed (Top dead center) | 600 rpm or higher |
| Engine speed (30°CA) | 600 rpm or higher |
| Starter | OFF |
| Time after starter ON to OFF | 3 seconds or more |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Starter | ON |
| Minimum battery voltage starter ON | Less than 11 V |