DTC P0111: Intake Air Temperature Sensor 1 Circuit Range / Performance [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTC P0111 and other DTCs are output A DTC P0111 is output B HINT:
- If any DTCs other than P0111 are output, troubleshoot those DTCs first.
- Perform "Inspection After Repair" after replacing the mass air flow meter (Refer to INITIALIZATION [12/2015 - 08/2016] ).
Result:
A
GO TO DTC CHART
(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 08/2016] )
Result:
B
REPLACE MASS AIR FLOW METER
(Refer to REMOVAL [12/2015 - 08/2016] )