Typical Enabling Conditions
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
ALL:
| Monitor runs whenever the following DTCs are not stored | None |
CASE 1:
| All of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Ignition switch | Off |
| CPU clock elapsed time | 1.96608 seconds or more |
CASE 2:
| All of the following conditions are met | - |
| Internal engine OFF timer (elapsed time from engine stop) | 10 minutes or more, and less than 30 minutes |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | Off |
CASE 3:
| All of the following conditions are met | - |
| Internal engine OFF timer (elapsed time from engine stop) | 10 minutes or more, and less than 40 minutes |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | Off |