Inspection [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT PURGE VSV
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*a Component without harness connected
(Purge VSV)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 23 to 26 Ω If the result is not as specified, replace the purge VSV.
- Check operation of the purge VSV.
- Check that air does not flow from port E to port F.TEXT IN ILLUSTRATION
*1 Port F *2 Port E *a Air - Apply battery voltage across the terminals.TEXT IN ILLUSTRATION
*1 Port F *2 Port E *a Component without harness connected
(Purge VSV)*b Air - Check that air flows from port E to port F.
If the result is not as specified, replace the purge VSV.
- Check that air does not flow from port E to port F.
- Measure the resistance according to the value(s) in the table below.