Installation [11/2017 - ]: Procedure

1. Install the 2 lower radiator supports to the radiator assembly.

1. Install the 2 radiator support cushions to the radiator assembly.

1. Install the radiator drain cock plug to the radiator assembly.
   NOTE:

   Replace the O-ring if it is damaged.

2. Engage the 3 guides.
3. Engage the 2 claws to install the fan shroud assembly to the radiator assembly.
   NOTE:

   Do not damage the radiator assembly when installing the fan shroud assembly.

4. Connect the radiator reserve tank hose to the radiator assembly.
5. Install the radiator assembly with the fan shroud assembly to the vehicle body.
   NOTE:

   Do not apply excessive force to the cooler condenser assembly or pipe when installing the radiator assembly with the fan shroud assembly.

6. Engage the 3 wire harness clamps.
7. Connect the cooling fan ECU connector.
8. Install the 2 bolts.

   Torque: 7.1 N*m (72 kgf*cm, 63 in.*lbf) 

1. Install the upper radiator support with the 5 bolts.

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

2. Connect the 2 horn connectors.
3. Connect the clamp of the hood lock control cable.

Refer to PROCEDURE - Step 6

Refer to PROCEDURE - Step 9

Refer to INSTALLATION [11/2017 - ]

1. Connect the No. 1 outlet oil cooler hose and slide the clip to secure it.

1. Connect the No. 2 inlet oil cooler hose and slide the clip to secure it.
2. Engage the clamp to connect the No. 2 inlet oil cooler hose to the fan shroud assembly.

1. Connect the No. 2 radiator hose and slide the clip to secure it.

1. Connect the No. 1 radiator hose and slide the clip to secure it.

Refer to PROCEDURE - Step 67

See step  3

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 15