LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) >> Hood >> Adjustment [11/2017 - ] >> Procedure

Adjustment [11/2017 - ]: Procedure

  1. ADJUST HOOD SUB-ASSEMBLY 
    1. Loosen the 4 hood side hinge bolts.
      GTY299031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Move the hood to adjust the clearance to within the standard range.

      See step  1

    3. Tighten the 4 hood side hinge bolts after the adjustment.

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

    4. Adjust the height of the hood front end by turning the cushion rubber.

      See step  1

      GTY299038Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      The cushion rubber can be raised and lowered by turning it.

  2. REMOVE RADIATOR GRILLE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  3. REMOVE HOOD LOCK NUT CAP 

    See step  4

  4. ADJUST HOOD LOCK ASSEMBLY 
    1. Loosen the 3 bolts.
      GTY691437Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Adjust the hood lock position so that the striker can enter it smoothly.
      GTY306294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Tighten the 3 bolts after the adjustment.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

  5. INSTALL HOOD LOCK NUT CAP 

    See step  9

  6. INSTALL RADIATOR GRILLE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

scientia non olet · About LEMON Manuals