LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostics - Introduction (2 Of 2) >> Meter / Gauge System >> Data List / Active Test [12/2015 - 08/2016] >> Data List / Active Test [12/2015 - 08/2016]

Data List / Active Test [12/2015 - 08/2016]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / Combination Meter / Data List.
    7. According to the display on the Techstream, read the Data List.
      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW ODO/TRIP switch/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed -
      P-Seatbelt Buckle SW Front passenger side seat belt buckle switch/
      OFF or ON      		 OFF: Front passenger side seat belt unfastened -
      ON: Front passenger side seat belt fastened
      Vehicle Speed Meter Vehicle speed/
      Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)      		 Approximately same as actual vehicle speed (When vehicle is being driven) -
      Engine Rpm Engine speed/
      Min.: 0 rpm, Max.: 12750 rpm      		 600 to 700 rpm: Idling -
      Coolant Temperature Engine coolant temperature/
      Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)      		 80 to 100°C (176 to 212°F): After warming up -
      Washer Switch Washer level warning switch/
      OFF or ON      		 OFF: Washer level warning switch off -
      ON: Washer level warning switch on
      Check Engine SW MIL/
      OFF or ON      		 OFF: MIL off -
      ON: MIL on
      Light Control Switch Light control switch knob/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Display Select Switch Steering pad switch (DISP)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      +B Voltage Value Battery voltage/
      Min.: 0 V, Max.: 25.5 V      		 11 to 14 V -
      Integrated value for Maintenance*1 Maintenance required reminder value/
      Min.: 0, Max.: 25500 (mile)      		 Driving distance after performing maintenance required reminder reset procedure displayed If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.
      Fuel Input Fuel input signal/
      Min.: 0, Max.: 127.5      		 Current fuel level displayed Unit: Liter
      Ambient Temperature Outside temperature/
      Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)      		 Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F).
      TPMS Operation State Condition of tire pressure warning system/
      OFF, ON or Unknown      		 OFF: Tire pressure warning system not operating -
      ON: Tire pressure warning system operating
      Unknown: Wire harness between combination meter assembly and tire pressure warning ECU open
      Multi Switch (Up)*2 Drive monitor switch (Up)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Down)*2 Drive monitor switch (Down)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Menu)*2 Steering pad switch (Menu)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Enter)*2 Steering pad switch (Enter)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Right)*2 Steering pad switch (Right)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Left)*2 Steering pad switch (Left)/
      OFF or ON      		 OFF: Switch released -
      ON: Switch pushed
      Oil Pressure Switch Engine oil pressure switch/
      OFF or ON      		 OFF: Engine oil pressure low -
      ON: Engine oil pressure except above
      Turn Signal Switch (Right) RH turn signal switch/
      OFF or ON      		 OFF: RH turn signal switch off -
      ON: RH turn signal switch on
      Turn Signal Switch (Left) LH turn signal switch/
      OFF or ON      		 OFF: LH turn signal switch off -
      ON: LH turn signal switch on
      Hazard Flasher Switch Hazard warning signal switch/
      OFF or ON      		 OFF: Hazard warning signal switch off -
      ON: Hazard warning signal switch on
      Turn Switch Signal (Full Turn) Turn switch signal/
      OFF or ON      		 OFF: LH or RH turn switch off -
      ON: LH or RH turn switch on
      Multi Switch (Back)*2 Steering pad switch (Back)/ OFF: Switch released -
      ON: Switch pushed
      Key Remind Sound*3 Cycle of key reminder warning buzzer/
      Normal, Slow or Fast      		 Cycle of key reminder warning buzzer is Fast, Normal or Slow The current setting of the cycle of the key reminder warning buzzer is displayed.
      Key Remind Volume*3 Cycle of key reminder warning buzzer/
      Large, Small or Medium      		 Cycle of key reminder warning buzzer is Large, Medium or Small The current setting of the cycle of the key reminder warning buzzer is displayed.
      Driver Side Seatbelt Warning Buzzer Condition of the driver side seat belt warning buzzer/
      OFF or ON      		 ON: Driver side seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened The customized setting of the driver side seat belt warning buzzer is displayed.
      OFF: Driver side seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened
      P-Seatbelt Warning Buzzer Condition of the front passenger side seat belt warning buzzer/
      OFF or ON      		 ON: Front passenger side seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened The customized setting of the front passenger side seat belt warning buzzer is displayed.
      OFF: Front passenger side seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened
      ODO Display Time After IG OFF Setting Condition of the ODO display time after the ignition switch is turned off/
      30s, 60s, 600s or OFF      		 Displays customize setting of ODO display time after IG off setting -
      Lane Change Flashing Times Setting Condition of the lane change flashing times
      OFF, 3, 4, 5, 6 or 7      		 Displays customize setting of lane change flashing times setting -
      Flasher Sound Volume Adjustment Condition of the flasher sound volume adjustment
      Small, Medium or Large      		 Displays customize setting of flasher sound volume adjustment -
      LDA System Not available - -
      Radar Cruise System*4 Existence of function
      With or Without      		 With: w/ Dynamic radar cruise control system -
      Without: w/o Dynamic radar cruise control system
      Number of Trouble Code The number of the DTC which is currently output 0 -
      1. *1: w/ Maintenance Required Reminder
      2. *2: w/ Multi-information Display
      3. *3: w/o Smart Key System
      4. *4: w/ Dynamic Radar Cruise Control System
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    7. According to the display on the Techstream, perform the Active Test.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40, 80, 120*1, 160*1 Operate with IG ON and the vehicle is stopped.
      Acceptable range (km/h or mph): [Control range → Speedometer display]
      for mph
      • 40 → 39.15 to 42.65
      • 80 → 79.65 to 84.15

      for km/h
      • 40 → 38.95 to 42.95
      • 80 → 78.9 to 84.9
      • 120 → 119.8 to 125.8
      • 160 → 159.8 to 167.8
      TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 Operate with IG ON and the vehicle is stopped.
      Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F Operate with IG ON and the vehicle is stopped.
      A/T Indicator Operation 1 A/T shift indicator light (D, P, N. R, 4, 3, 2, L) OFF, L, 2, 3 (M), 4 (M), D, N, R, P Operate with IG ON and the vehicle is stopped.
      A/T Indicator Operation 2 A/T gear range indicator light (S, 6, 5) OFF, 5, 6, Es Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Airbag SRS warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Doors All Open*1 Door indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Driver Side Seat Belt Driver side seat belt warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp ABS ABS warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Charge*1 Charge warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Slip Slip indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Beam High beam indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Head*2 Head indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Tail*3 Tail indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Fr FOG*4 Front fog indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Precrash*5 PCS warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Fuel Fuel level warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Tire Pressure Warning System Tire Pressure warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Oil Pressure*1 Oil pressure warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. ECONO Eco Driving Indicator Light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Cruise*1 Cruise main indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. Lamp Brake Brake warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. EPS Power steering warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Master Warning Master warning light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. SET*1 Cruise set indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Indicat. VSC OFF VSC OFF indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Automatic High Beam Indicator*6 Automatic high beam indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON Operate with IG ON and the vehicle is stopped.
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH Operate with IG ON and the vehicle is stopped.
      Meter Display 1 Multi-information display OFF, 6, 5, 4, 3, 2, 1, 0, All Operate with IG ON and the vehicle is stopped.
      1. *1: for Multi-information Display (Monochrome Type)
      2. *2: for U.S.A.
      3. *3: except U.S.A.
      4. *4: w/ Front Fog Light
      5. *5: w/ Pre-collision System
      6. *6: w/ Automatic High Beam System
scientia non olet · About LEMON Manuals