Installation [12/2015 - ]: Procedure

1. Install the front stabilizer bar from the left side of the vehicle.

1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	Cutout
   *b	Front of the Vehicle
   *c	Inside of the Vehicle

   NOTE:

   When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.

1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

HINT: 

Perform the same procedure as the LH side.

1. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

   Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) 

HINT: 

Perform the same procedure as the LH side.

1. Install the front stabilizer link assembly LH with the 2 nuts.

   for Upper Side 

   Torque: 130 N*m (1326 kgf*cm, 96 ft.*lbf) 

   for Lower Side 

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

HINT: 

Perform the same procedure as the LH side.

Refer to PROCEDURE - Step 3 [12/2015 - 08/2016] , or refer to PROCEDURE - Step 3 [08/2016 - ]

Refer to PROCEDURE - Step 40 [12/2015 - 08/2016] , or refer to PROCEDURE - Step 43 [08/2016 - ]

(Refer to INSTALLATION [12/2015 - 08/2016] , or refer to INSTALLATION [08/2016 - ] )

(Refer to INSTALLATION [12/2015 - 08/2016] , or refer to INSTALLATION [08/2016 - ] )