Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
OFF malfunction
- When one of the following conditions is met: OFF malfunction (A), (B), (C) or (D)OFF MALFUNCTION (A)
ECM selected gear 3rd Turbine speed - Output speed x (ECM selected gear) 1000 rpm or more OFF MALFUNCTION (B)ECM selected gear 5th Turbine speed - Output speed x (ECM selected gear) 1000 rpm or more OFF MALFUNCTION (C)ECM selected gear 4th Turbine speed - Output speed x (ECM selected gear) 1000 rpm or more OFF MALFUNCTION (D)Shift solenoid valve SLT ON malfunction ECM selected gear 1st or 2nd or 3rd or 4th or 5th 1st gear pass detection Not fixed 2nd gear pass detection Not fixed 3rd gear pass detection Not fixed 4th gear pass detection Not fixed 5th gear pass detection Not fixed
ON malfunction
- When one of the following conditions is met: ON malfunction (A), (B), (C), (D), (E) or (F)ON MALFUNCTION (A)
When either condition below is met: (a) or (b) - (a) Turbine speed/Output speed (NT/NO) 0.934 or more and 1.065 or less
(When Output speed less than 750 rpm)(b) Turbine speed - Output speed x 4th gear ratio -50 rpm or more and 50 rpm or less
(When Output speed 750 rpm or more)ON MALFUNCTION (B)When either condition below is met: (a) or (b) - (a) Turbine speed/Output speed (NT/NO) 0.934 or more and 1.065 or less
(When Output speed less than 750 rpm)(b) Turbine speed - Output speed x 5th gear ratio -50 rpm or more and 50 rpm or less
(When Output speed 750 rpm or more)ON MALFUNCTION (C)When either condition below is met: (a) or (b) - (a) Turbine speed/Output speed (NT/NO) 0.737 or more and 0.867 or less
(When Output speed less than 750 rpm)(b) Turbine speed - Output speed x 3rd gear ratio -50 rpm or more and 50 rpm or less
(When Output speed 750 rpm or more)ON MALFUNCTION (D)When either condition below is met: (a) or (b) - (a) Turbine speed/Output speed (NT/NO) 0.737 or more and 0.867 or less
(When Output speed less than 750 rpm)(b) Turbine speed - Output speed x 5th gear ratio -50 rpm or more and 50 rpm or less
(When Output speed 750 rpm or more)ON MALFUNCTION (E)When either condition below is met: (a) or (b) - (a) Turbine speed/Output speed (NT/NO) 0.621 or more and 0.725 or less
(When Output speed less than 950 rpm)(b) Turbine speed - Output speed x 5th gear ratio -50 rpm or more and 50 rpm or less
(When Output speed 950 rpm or more)ON MALFUNCTION (F)Shift solenoid valve SLT ON malfunction ECM selected gear 6th or 7th or 8th 6th gear pass detection Not fixed 7th gear pass detection Not fixed 8th gear pass detection Not fixed