Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Perform the universal trip to clear permanent DTCs.
Refer to DTC CHECK / CLEAR [08/2016 - ]
- Perform registration and/or initialization when parts related to the automatic transmission are replaced.
Refer to PRECAUTION [08/2016 - ]
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Transmission / Active Test.
- According to the display on the Techstream, perform the Active Test.TRANSMISSION
Tester Display Test Part Control Range Diagnostic Note Activate the Lock Up Solenoid Controls the shift solenoid valves SLU and SL to set the automatic transmission to the lock-up condition. ON/OFF Can be used to check shift solenoid valves SLU and SL operation.
[Vehicle Condition]
Vehicle speed: 60 km/h (36 mph) or moreHINT:
- This test can be conducted when the vehicle speed is 80 km/h (50 mph) or more.
- Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.
HINT:
- When changing the accelerator pedal opening angle while driving, if the engine speed does not change, lock-up is on.
- Slowly release the accelerator pedal in order to decelerate, but do not fully release the pedal. (Fully releasing the pedal will close the throttle valve and lock-up may be turned off.)