DTC P0500-31: Vehicle Speed Sensor "A" No Signal [11/2017 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the Ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Transmission / Data List.
5. Drive the vehicle.
6. In accordance with the display on the Techstream, read the Data List.

   Transmission

   Techstream Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed	Vehicle speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph)	Actual vehicle speed	This is the current vehicle speed. The vehicle speed is detected using the wheel speed sensors. There is a delay in when the vehicle speed data is displayed. Therefore, even if the vehicle speed listed in the freeze frame data is 0 km/h (0 mph), this does not always mean that the malfunction occurred when the vehicle was stopped.

   OK

   Vehicle speed displayed on Techstream and speedometer display are equal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - ] 

Result: 

NG 

See step  2

1. Check the circuits that send vehicle speed signals to this system in the meter system.

   Refer to Speed Signal Circuit [11/2017 - ]

2. During inspection for the meter section, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Disconnect the D145 combination meter assembly connector.
2. Disconnect the A69 ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D145-3 (+S) - A69-39 (SPD)	Always	Below 1 Ω
   D145-3 (+S) or A69-39 (SPD) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Replace the ECM.

   Refer to COMPONENTS [08/2016 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM A/T CODE REGISTRATION. Refer to  REGISTRATION [08/2016 - ]