Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| The monitor will run whenever the following DTCs are not stored | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Engine | Running |
| Intermediate shaft speed sensor revolution | 300 rpm or more |
| Shift change | Shift change is completed before starting next shift change operation |
| R position switch | OFF |
| D position switch | ON |
| Park/neutral position switch (NSW) | OFF |
| Pressure control solenoid circuit fail (P08C1, P08C2, P0962, P0963, P0966, P0967, P0970, P0971, P2720, P2721, P2814, P2815, P281D, P281E) | Not detected |
| Torque Converter Clutch Pressure Control Solenoid circuit fail (P2763, P2764) | Not detected |
| Torque Converter Clutch Solenoid circuit fail (P2769, P2770) | Not detected |
| Either a or b is met (See below) | - |
| a. All of the following conditions are met | - |
| ECT | 20°C (68°F) or more |
| ECT sensor circuit fail (P0117, P0118) | Not detected |
| b. All of the following conditions are met | - |
| ECT | Less than 20°C (68°F) |
| ECT sensor circuit fail (P0117, P0118) | Detected |
| Any one of the following conditions is met | Conditions 1, 2, 3, 4, 5 or 6 |
| 1. All of the following conditions are met | - |
| ECM selected gear | 1st |
| Turbine speed sensor revolution | 1450 rpm or more |
| 2. All of the following conditions are met | - |
| ECM selected gear | 2nd |
| Turbine speed sensor revolution | 840 rpm or more |
| 3. All of the following conditions are met | - |
| ECM selected gear | 3rd |
| Turbine speed sensor revolution | 540 rpm or more |
| 4. All of the following conditions are met | - |
| ECM selected gear | 4th |
| Turbine speed sensor revolution | 400 rpm or more |
| 5. All of the following conditions are met | - |
| ECM selected gear | 5th |
| Turbine speed sensor revolution | 330 rpm or more |
| 6. All of the following conditions are met | - |
| ECM selected gear | 6th, 7th, and 8th |
| Turbine speed sensor revolution | 300 rpm or more |