LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle System [UA80E] (Service Information)) >> Shift Lever >> Reassembly [08/2016 - ] >> Procedure

Reassembly [08/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL LOWER POSITION INDICATOR HOUSING 
    1. Put the guide in position and engage the 2 claws to install the lower position indicator housing to the shift lock control unit assembly.
      GTY732944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER 
    1. Install the No. 2 position indicator slide cover to the position indicator slide cover.
      GTY727269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL POSITION INDICATOR SLIDE COVER 
    1. Install the position indicator slide cover to the lower position indicator housing as shown in the illustration.
      GTY727271Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL UPPER POSITION INDICATOR HOUSING 
    1. Engage the 4 claws to install the upper position indicator housing to the lower position indicator housing.
      GTY723628Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY 
    1. Engage the 3 claws to install the shift lock control ECU sub-assembly to the shift lock control unit assembly.
      GTY723630Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the connector.
  6. INSTALL POSITION INDICATOR LED 
    1. Engage the claw to install the position indicator LED to the lower No. 2 position indicator housing.
      GTY726049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL POSITION INDICATOR LIGHT GUIDE 
    1. Engage the 4 claws to install the position indicator light guide to the lower No. 2 position indicator housing.
      GTY739620Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSTALL LOWER NO. 2 POSITION INDICATOR HOUSING 
    1. Engage the 5 claws to install the lower No. 2 position indicator housing to the floor shift position indicator housing sub-assembly.
      GTY726050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY 
    1. Connect the connector and engage 2 clamps to install the indicator light wire sub-assembly to the lower No. 2 position indicator housing.
      GTY726051Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL SHIFT LEVER CAP 
    1. Install the shift lever cap to the floor shift position indicator housing sub-assembly.
      GTY739621Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals