Adjustment [08/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

ADJUST SHIFT LEVER POSITION

Move the shift lever to N.

Disconnect the transmission control switch connector and shift lock control ECU connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Transmission Control Switch Connector
*2	Shift Lock Control ECU Connector

Disengage the clamp to separate the wire harness from the shift lever assembly.
Remove the 4 nuts and shift lever assembly from the instrument panel reinforcement.

Disconnect the end of the transmission control cable assembly from the shift lever assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, pull out the stopper of the transmission control cable assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

Rotate the nut of the transmission control cable assembly counterclockwise approximately 270° and while holding the nut in that position, separate the cable outer of the transmission control cable assembly from the shift lever retainer.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Rotate the nut of the transmission control cable assembly counterclockwise approximately 270° and while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Stopper
*2	Nut
*a	Turn
*b	Push

Push the lock piece up from the back side of the adjuster case while pinching the claws on the lock piece.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Adjuster Case
*2	Claw
*3	Lock Piece

Check that the park/neutral position switch and the shift lever are in N position.

Install the cable outer of the transmission control cable assembly to the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

Connect the end of the transmission control cable assembly to the shift lever assembly.

*1	Lock Piece

NOTE:

Check that the lock piece is pulled up.

Install the shift lever assembly to the instrument panel reinforcement with the 4 nuts.
Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
Engage the clamp to install the wire harness to the shift lever assembly.
Connect the shift lock control ECU connector and transmission control switch connector.

Press in and lock the lock piece to the adjuster case.

*1	Lock Piece
*2	Adjuster Case
*a	Press in

NOTE:

Check that the park/neutral position switch and shift lever are in N position.
Securely press in the lock piece until the lock engages.

INSPECT SHIFT LEVER POSITION
See step 1