Reassembly [08/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL RING PIN

Install the 2 ring pins to the front oil pump cover sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT OIL PUMP BODY

Install the front oil pump body to the front oil pump cover sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT OIL PUMP DRIVEN GEAR

Apply a light coat of Toyota Genuine ATF WS to the, front oil pump driven gear and install it to the front oil pump body.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT OIL PUMP DRIVE GEAR

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Apply a light coat of Toyota Genuine ATF WS to the front oil pump drive gear and install it to the front oil pump body.

INSTALL STATOR SHAFT ASSEMBLY

Install the stator shaft assembly to the front oil pump body with the 5 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 9.1 N*m (93 kgf*cm, 81 in.*lbf)

Bolt Length

Bolt (A)	Bolt (B)
50 mm (1.97 in.)	45 mm (1.77 in.)

INSTALL OIL STRAINER ASSEMBLY

Using a T30 "TORX" socket wrench, install a new oil strainer assembly to the front oil pump cover sub-assembly with the 2 bolts.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

INSTALL CLUTCH DRUM OIL SEAL RING

Apply a small amount of MP grease to the entire circumference of the clutch drum oil seal ring installation groove portion.

HINT:

By applying MP grease, the wobble within the clutch drum oil seal ring installation groove will be eliminated, preventing damage to the clutch drum oil seal ring at the time of front oil pump assembly installation.

Install the clutch drum oil seal ring to the front oil pump assembly.
NOTE:
While making the spread of the opening of the clutch drum oil seal ring as small as possible, install it to the front oil pump assembly.

If the ring opening is spread, briefly hold it closed with your fingers to return it to its original condition.