Installation [12/2015 - 08/2016]: Procedure

1. Apply MP grease to a new engine rear oil seal lip.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1	Retainer
   *a	Oil seal tap in depth (-0.5 to 0.5 mm)

2. Using SST and a hammer, tap in the engine rear oil seal.
   • SST: 09223-15030 
   • SST: 09950-70010 
     1. 09951-07150

   Oil seal tap in depth

   -0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

1. Using SST, hold the crankshaft pulley.
   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 
2. Clean the 8 bolts and 8 bolt holes.
3. Install the front drive plate spacer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

4. Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1	Drive Plate
   *2	Rear Spacer
   	Transaxle Side

5. Apply adhesive to 2 or 3 threads of the 8 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *1

   Adhesive

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

6. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
   Fig 1: Drive Plate And Ring Gear Sub-Assembly Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 83 N*m (846 kgf*cm, 61 ft.*lbf) 

   NOTE:

   Do not start the engine for at least an hour after installing the drive plate.

(Refer to INSTALLATION [12/2015 - 08/2016] )

(Refer to INSTALLATION [12/2015 - 08/2016] )