LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) (Service Information) >> Stop Light Switch >> Installation [12/2015 - ] >> Procedure

Installation [12/2015 - ]: Procedure

  1. INSTALL STOP LIGHT SWITCH ASSEMBLY 
    GTY305729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    TEXT IN ILLUSTRATION

    *1 Brake Pedal
    *2 Adjuster
    *3 Stop Light Switch
    1. Install the stop light switch into the adjuster until it slightly touches the brake pedal.

      HINT: 

      Do not depress the brake pedal.

      1. Make a quarter turn clockwise to install the stop light switch.
        GTY300948Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        TEXT IN ILLUSTRATION

        *1 Shaft
        *2 Stop Light Switch
        *a Stop Light Switch Clearance

        HINT: 

        • Do not depress the brake pedal.
        • The turning torque for installing the stop light switch is as below.

        Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

        or less

    2. Check the stop light switch clearance.

      Stop light switch clearance

      0.5 to 2.6 mm (0.020 to 0.102 in.)

    3. Connect the stop light switch connector to the stop light switch.
scientia non olet · About LEMON Manuals