How To Proceed With Troubleshooting [12/2015 - ]: Procedure

VEHICLE BROUGHT TO WORKSHOP
Result

Proceed to

NEXT

Result:

NEXT

See step 2
INSPECT BATTERY VOLTAGE
Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Proceed to

NEXT

Result:

NEXT

See step 3

CHECK CAN COMMUNICATION SYSTEM*

Use the Techstream to check if the CAN communication system is functioning normally.

Result

Result	Proceed to
CAN communication DTC is not output	A
CAN communication DTC is output	B

Result:

B

GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - ]

Result:

A

See step 4

REFER TO PROBLEM SYMPTOMS TABLE

Result

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

Result:

B

See step 6

Result:

A

See step 5

CONDUCT OVERALL ANALYSIS AND TROUBLESHOOTING*

Data List/Active Test
Refer to DATA LIST / ACTIVE TEST [12/2015 - 08/2016] Refer to DATA LIST / ACTIVE TEST [08/2016 - 11/2017] Refer to DATA LIST / ACTIVE TEST [11/2017 - ]
Terminals of ECU
Refer to TERMINALS OF ECU [12/2015 - 08/2016] Refer to TERMINALS OF ECU [08/2016 - ]

On-vehicle Inspection

Refer to ON-VEHICLE INSPECTION [12/2015 - 11/2017] Refer to ON-VEHICLE INSPECTION [11/2017 - ]

Result

Proceed to
NEXT

Result:

NEXT

See step 6

ADJUST, REPAIR OR REPLACE
Result

Proceed to

NEXT

Result:

NEXT

See step 7
CONDUCT CONFIRMATION TEST*
Result

Proceed to

NEXT

Result:

NEXT

END