Inspection [08/2015 - ]: Procedure

1. Check the tires for wear and proper inflation pressure.
   STANDARD COLD TIRE INFLATION PRESSURE
   
   

   Tire Size	Front kPa (kgf/cm2 , psi)	Rear kPa (kgf/cm2 , psi)
   P275/65R18 114T	230 (2.3, 33)	230 (2.3, 33)
   P275/55R20 111H	210 (2.1, 30)	230 (2.3, 33)
   P255/70R18 112T (Spare Tire)	230 (2.3, 33)

2. Using a dial indicator, check the tire runout.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Tire runout

   3.0 mm (0.118 in.) or less

1. Rotate the tires as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   for Aluminum Wheel 

   Torque: 131 N.m (1336 kgf/cm, 97 ft.lbf) 

   for Steel Wheel 

   Torque: 209 N.m (2131 kgf/cm, 154 ft.lbf) 

   TEXT IN ILLUSTRATION
   
   

   *a	Front of the Vehicle

   NOTE:

   The steel wheel for this vehicle indicates a spare tire.

1. Check and adjust the off-the-car balance.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
   • Do not touch the sticking surface of the tape.
   • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

     Width (A)

     25 mm (0.984 in.)

   • Push the balance weight firmly to adhere it to the position.
   • Do not reuse the balance weight.

   HINT: 

   If necessary, check and adjust the on-the-car balance.

(Refer to ON-VEHICLE INSPECTION [08/2015 - ] )

(Refer to ON-VEHICLE INSPECTION [08/2015 - ] )