Inspection [08/2015 - ]: Procedure

INSPECT REAR STABILIZER LINK ASSEMBLY LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.
  Torque: 0.05 N.m (1.96 N.m (0.51 kgf/cm, 20.0 kgf/cm, 4.51 in.lbf) 17.3 in.lbf)
  
  If the value is not within the specified range, replace the front suspension toe control link with a new one.
3. Check the dust boot for cracks or grease leakage.