Removal [08/2015 - ]: Procedure
- REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH
- Insert a piece of wood between the jack and the No. 2 lower arm, and raise the No. 2 lower arm.
- Remove the bolt.
- Remove the clip on the upper side of the rear pneumatic cylinder.
- Disconnect the height control tube (Refer to PRECAUTION [08/2015 - ] ).
- Gently lower the jack and remove the rear pneumatic cylinder.
- Insert a piece of wood between the jack and the No. 2 lower arm, and raise the No. 2 lower arm.