Caution / Notice / Hint

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION [08/2015 - 08/2017] ).
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2017] ).

HINT:

Perform the simulation method by selecting "check mode" (signal check) with the Techstream (Refer to CHECK MODE PROCEDURE [08/2015 - 08/2017] ).
After selecting "check mode" (signal check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on various types of roads (Refer to CHECK MODE PROCEDURE [08/2015 - 08/2017] ).