Caution / Notice / Hint
NOTE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [08/2017 - 08/2019]
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Refer to
HINT:
To perform the simulation method, enter check mode (signal check) with the Techstream (Refer to DTC CHECK / CLEAR [08/2017 - 08/2019] ), and then wiggle each connector of the airbag system or drive the vehicle on various types of road. Refer to