Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List.
- According to the display on the Techstream, read the Data List.ENGINE AND ECT
Tester Display Measurement Item/Range Normal Condition Diagnostic Note A/T Oil Temperature 2 No. 2 ATF temperature sensor value/
Min.: -40°C (-40°F)
Max.: 150°C (302°F)- After stall test: Approximately 80°C (176°F)
- Equal to ambient temperature while engine is cold
If value is -40°C (-40°F) or 150°C (302°F), No. 2 ATF temperature sensor circuit is open or shorted HINT:
- When DTC P2742 is output and the Techstream output is 150°C (302°F) or higher, there is a short circuit.
- When DTC P2743 is output and the Techstream output is -40°C (-40°F), there is an open circuit.
Measure the resistance between terminal THO2 and the body ground.
Temperature Displayed Malfunction -40°C (-40°F) Open circuit 150°C (302°F) or higher Short circuit