Monitor Description
WARNING: This page is about a different variant/trim than selected.
These DTCs indicate an open or short in the shift solenoid valve S4 circuit. When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem, illuminates the MIL and stores the DTC. When the shift solenoid valve S4 is ON, if its resistance is 8 Ω or less, the ECM determines there is a short in the shift solenoid valve S4 circuit.
When the shift solenoid valve S4 is OFF, if its resistance is 100 kΩ or more, the ECM determines there is an open in the shift solenoid valve S4 circuit (Refer to FAIL-SAFE CHART [08/2015 - ] ).