Monitor Description
WARNING: This page is about a different variant/trim than selected.
These DTCs indicate an open or short in the shift solenoid valve S2 circuit. When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem, illuminates the MIL and stores the DTC. When the shift solenoid valve S2 is ON, if its resistance is 8 Ω or less, the ECM determines there is a short in the shift solenoid valve S2 circuit.
When the shift solenoid valve S2 is OFF, if its resistance is 100 kΩ or more, the ECM determines there is an open in the shift solenoid valve S2 circuit (Refer to FAIL-SAFE CHART [08/2015 - ] ).