Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
[OFF malfunction]
- Both of the following conditions are met: OFF malfunction (A) and OFF malfunction (B) or (C)
OFF MALFUNCTION (A)
| Turbine speed/Output speed (NT/NO) | 0.66 or more, and 0.80 or less (This means actual gear is 5th) |
OFF MALFUNCTION (B)
| Turbine speed-Output speed x 5th gear ratio (NT-NO x 5th gear ratio) |
1000 RPM or more |
OFF MALFUNCTION (C)
| Turbine speed-Output speed x 6th gear ratio (NT-NO x 6th gear ratio) |
1000 RPM or more |
[ON malfunction]
- Both of the following conditions are met: ON malfunction (A) and (B)
- 2 detections are necessary per driving cycle:
- 1st detection: temporary flag ON
- 2nd detection: pending fault code ON
ON MALFUNCTION (A)
| Turbine speed/Output speed (NT/NO) | 1.83 or more, and 2.27 or less (This means actual gear is 2nd) |
ON MALFUNCTION (B)
| Turbine speed/Output speed (NT/NO) | 0.66 or more, and 0.80 or less (This means actual gear is 5th) |