Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| The monitor will run whenever the following DTCs are not present | P0705 (Park/neutral position switch circuit) P0751, P0973, P0974 (Shift solenoid valve S1) P0756, P0976, P0977 (Shift solenoid valve S2) P0761, P0979, P0980 (Shift solenoid valve S3) P0766, P0982, P0983 (Shift solenoid valve S4) P0748 (Shift solenoid valve SL1 circuit) P0776, P0778 (Shift solenoid valve SL2) |
| Shift change | After shift change is completed and before starting next shift change operation |
| ECM selected gear | 4th, 5th or 6th |
| Output shaft RPM | 1000 RPM or more |
| NSW switch | OFF |
| R switch | OFF |
| Engine | Running |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |