Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Battery voltage | 8 V or higher |
| Engine switch | On (IG) |
| Starter | OFF |
P0712: Range check (Low voltage)
P0713: Range check (High voltage)
- One of the following conditions is met: Condition (A) or (B)
Condition (A)
The monitor will run whenever this DTC is not present P0115, P0117, P0118 (ECT (Engine coolant temperature) sensor circuit)
P00AC, P00AD, P0110, P0112, P0113 (IAT (Intake air temperature) sensor circuit)Engine coolant temperature or intake air temperature at engine start -29.375°C (-20.875°F) or less Time after engine start 388 seconds or more
Condition (B)
The monitor will run whenever this DTC is not present P0115, P0117, P0118 (ECT (Engine coolant temperature) sensor circuit)
P00AC, P00AD, P0110, P0112, P0113 (IAT (Intake air temperature) sensor circuit)Engine coolant temperature and intake air temperature at engine start Higher than -29.375°C (-20.875°F) Time after engine start 10 seconds or more