DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [08/2015 - 08/2017]: Description

WARNING: This page is about a different variant/trim than selected.

The Park/Neutral Position (PNP) switch detects the shift lever position and sends signals to the ECM.

DTC Code	DTC Detection Condition	Trouble Area
P0705	When one of following conditions is met: (A) Any 2 or more of the following signals are ON simultaneously (2 trip detection logic): One of the following conditions is met. P input signal is ON N input signal is ON NSW input signal is ON R input signal D input signal (B) Any of following signals are ON for 2.0 seconds or more in S position (2 trip detection logic): P input signal N input signal NSW input signal R input signal (C) All signals are OFF simultaneously for P, N, NSW, R and D positions (2 trip detection logic	Open or short in park/neutral position switch circuit Park/neutral position switch Transmission control switch ECM

DTC Code

DTC Detection Condition

Trouble Area

P0705

When one of following conditions is met:
(A) Any 2 or more of the following signals are ON simultaneously (2 trip detection logic):

One of the following conditions is met.
1. P input signal is ON
2. N input signal is ON
3. NSW input signal is ON
R input signal
D input signal

(B) Any of following signals are ON for 2.0 seconds or more in S position (2 trip detection logic):