Inspection [08/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
- Measure the resistance according to the value(s) in the table below.
HINT:
If the resistance is out of the specified range of any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.
Standard Resistance
Tester Connection ATF Temperature Specified Condition 1 (OT-) - 9 (OT+) 10°C (50°F) 5 to 8 kΩ 1 (OT-) - 9 (OT+) 25°C (77°F) 2.5 to 4.5 kΩ 1 (OT-) - 9 (OT+) 110°C (230°F) 0.22 to 0.28 kΩ 2 (OT2-) - 10 (OT2+) 10°C (50°F) 5 to 8 kΩ 2 (OT2-) - 10 (OT2+) 25°C (77°F) 2.5 to 4.5 kΩ 2 (OT2-) - 10 (OT2+) 110°C (230°F) 0.22 to 0.28 kΩ If the result is not as specified, replace the transmission wire.
- Measure the resistance according to the value(s) in the table below.