LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System (3UR-FBE) (Service Information)) >> Mass Air Flow Meter >> Installation [08/2015 - 08/2018] >> Procedure

Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL MASS AIR FLOW METER 
    1. Install the MAF meter with the 2 screws.
      GTY588674Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 1.7 N.m (17 kgf/cm, 15 in.lbf) 

      HINT: 

      Perform "Inspection After Repairs" after replacing the mass air flow meter (Refer to INITIALIZATION [08/2015 - 08/2017] , or refer to INITIALIZATION [08/2017 - 08/2018] ).

    2. Connect the MAF connector.
scientia non olet · About LEMON Manuals