LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System (3UR-FBE) (Service Information)) >> Crankshaft Position Sensor >> Installation [08/2015 - 08/2018] >> Procedure

Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    GTY611276Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the sensor with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    2. Connect the sensor connector.
  2. INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR 
    1. Install the sensor protector with the 2 bolts.
      GTY608732Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

scientia non olet · About LEMON Manuals