LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System (3UR-FBE) (Service Information)) >> Camshaft Position Sensor >> Installation [08/2015 - 08/2018] >> Procedure

Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL VVT SENSOR 
    GTY611252Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the 4 sensors with the 4 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    2. Connect the 4 sensor connectors.
  2. INSTALL CAMSHAFT POSITION SENSOR 
    GTY588687Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the sensor with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    2. Connect the sensor connector.
  3. INSTALL AIR CLEANER HOSE ASSEMBLY 

    Refer to PROCEDURE - Step 13

  4. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

scientia non olet · About LEMON Manuals