LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control System (3UR-FBE) (Service Information)) >> Accelerator Pedal >> Installation [08/2015 - 08/2018] >> Procedure

Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY 
    NOTE:
    • Avoid physical shocks to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • This accelerator pedal does not require lubrication.

      Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

      If applied, the accelerator pedal sensor assembly must be replaced.

    1. Install the accelerator pedal sensor assembly with the 2 nuts.
      GTY602766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf) 

    2. Connect the accelerator pedal sensor connector.
scientia non olet · About LEMON Manuals