Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FAN & GENERATOR V BELT

Set the fan and generator V belt onto every part.

Fig 1: Drive Belt Routing Diagram
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
While turning the belt tensioner counterclockwise, remove the pin.
NOTE:
Make sure that the V belt is properly set to each pulley.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

After installing the belt, check that it fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 12
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 16