LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Control System (3UR-FBE) - Diagnostics - Introduction (1 Of 2)) >> SFI System >> Registration [08/2015 - 08/2018] >> Procedure

Registration [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. DESCRIPTION 
    NOTE:

    The Vehicle Identification Number (VIN) must be input into the replacement ECM.

    HINT: 

    This registration procedure consists of two parts: Read VIN and Write VIN.

    1. Read VIN: Explains the VIN reading process in a flowchart. This process allows the VIN stored in the ECM to be read in order to confirm that the two VINs, provided with the vehicle and stored in the vehicle's ECM, are the same.
    2. Write VIN: Explains the VIN writing process in a flowchart. This process allows the VIN to be input into the ECM. If the ECM is changed, or the ECM VIN and vehicle VIN do not match, the VIN can be registered, or overwritten in the ECM by following this procedure.
  2. READ VIN 
    1. Confirm the vehicle VIN.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Read.
  3. WRITE VIN 
    1. Confirm the vehicle VIN.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Write.
scientia non olet · About LEMON Manuals