DTC B2799: Engine Immobiliser System Malfunction [08/2019 - ]: Description

WARNING: This page is about a different car, the 2022 Toyota Sequoia, 2021 Toyota Sequoia, and 2020 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

If there is a communication malfunction between the ECM and certification ECU (smart key ECU assembly), or when the communication ID codes do not match, the ECM stores this DTC.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Note
B2799	Engine Immobiliser System Malfunction	Either of the following conditions is met (1 trip detection logic*): A malfunction is detected in the communication or communication lines between the ECM and certification ECU (smart key ECU assembly). The communication ID codes of the ECM and certification ECU (smart key ECU assembly) do not match.	Certification ECU (smart key ECU assembly) ECM Harness or connector	DTC output confirmation operation (Perform either of the following): Start the engine and wait for 10 seconds. If there is a malfunction, the engine will stop (communication begins within 3 seconds of the engine start, and DTCs are stored after 6 seconds). Connect the cable to the negative (-) battery terminal, start the engine and wait for 10 seconds (communication begins within 3 seconds of the engine switch being turned on (IG), and DTCs are stored after 6 seconds).

*: Only output while a malfunction is present.

VEHICLE CONDITION AND FAIL-SAFE OPERATION WHEN MALFUNCTION DETECTED

Vehicle Condition when Malfunction Detected	Fail-safe Operation when Malfunction Detected
Engine cannot be started	-

RELATED DATA LIST AND ACTIVE TEST

DTC No.	Data List and Active Test
B2799	-