Emergency Call Switch Illumination Circuit [08/2019 - ]: Procedure

1. Disconnect the H207 DCM (telematics transceiver) connector.
2. Disconnect the U7 roof console box assembly connector.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   U7-10 (IG) - Body Ground	Engine switch on (IG)	11 to 14 V

4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H207-3 (SIG-) - U7-14 (GND3)	Always	Below 1 Ω
   H207-3 (SIG-) or U7-14 (GND3) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Remove the roof console box assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Roof Console Box Assembly (Manual [SOS] Switch))

   Refer to REMOVAL [08/2019 - ]

2. Apply battery voltage to the connector and check that the manual (SOS) switch illumination comes on.

   OK

   Measurement Condition	Condition	Specified Condition
   Battery positive (+) → U7-10 (IG) Battery negative (-) → U7-14 (GND3)	Always	Manual (SOS) switch illumination comes on

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ROOF CONSOLE BOX ASSEMBLY (MANUAL [SOS] SWITCH). Refer to  REMOVAL [08/2019 - ] 

Result: 

OK 

See step  3

1. Replace the DCM (telematics transceiver) with a new one.

   Refer to REMOVAL [08/2019 - ]

   NOTE:

   • The engine switch must be off.
   • Do not exchange the DCM (telematics transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [08/2019 - ]