Removal [08/2019 - ]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Sequoia, 2021 Toyota Sequoia, and 2020 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Refer to PRECAUTION [08/2019 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2019 - ]
REMOVE ROOF HEADLINING ASSEMBLY
Refer to REMOVAL [08/2019 - ]

REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the washer and holder.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the telephone and GPS antenna assembly of the vehicle outside.

Detach the 3 claws and 3 guides and remove the telephone and GPS antenna assembly as indicated by the arrows in the order shown in the illustration.

Fig 1: Telephone And GPS Antenna Assembly Removal Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

When reusing the telephone and GPS antenna assembly:

Remove the seal.