Installation [08/2019 - ]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Sequoia, 2021 Toyota Sequoia, and 2020 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY

When reusing the telephone and GPS antenna assembly:

Install a new seal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Attach the 3 claws and 3 guides to install the telephone and GPS antenna assembly as indicated by the arrows in the order shown in the illustration.

Fig 1: Telephone And GPS Antenna Assembly Installation Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Temporarily install the telephone and GPS antenna assembly to the vehicle.

Insert a new washer and holder to install the telephone and GPS antenna assembly with the bolt.
Torque: 9.5 N.m (97 kgf/cm, 84 in.lbf)
Connect the connector.

INSTALL ROOF HEADLINING ASSEMBLY
Refer to INSTALLATION [08/2019 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2019 - ]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [08/2019 - ]