LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Cellular Communication System (Service Information)) >> TELEPHONE AND GPS ANTENNA (for Instrument Panel) >> Installation [08/2019 - ] >> Procedure

Installation [08/2019 - ]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Sequoia, 2021 Toyota Sequoia, and 2020 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY 
    1. While moving the telephone and GPS antenna assembly in the direction indicated in the illustration, attach the 4 guides to install it to the navigation antenna bracket.
      GTY850178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Attach the 2 claws to install the telephone and GPS antenna assembly.
  2. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY WITH BRACKET 
    1. Attach the 2 guides to temporarily install the telephone and GPS antenna assembly with bracket.
      GTY850144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 screws.
    3. Attach the 2 claws.
      GTY850141Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the connector.
  3. INSTALL DEFROSTER NOZZLE ASSEMBLY 

    Refer to PROCEDURE - Step 10

  4. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT 

    Refer to PROCEDURE - Step 12

  5. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT 

    Refer to PROCEDURE - Step 11

  6. INSTALL NO. 1 HEATER TO REGISTER DUCT 

    Refer to PROCEDURE - Step 13

  7. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to INSTALLATION [08/2019 - ]

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2019 - ]

  9. CHECK SRS WARNING LIGHT 

    Refer to OPERATION CHECK [08/2019 - ]

scientia non olet · About LEMON Manuals