DTC P0630: VIN not Programmed or Mismatch - ECM / PCM [08/2015 - 08/2018]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Read DTCs.
   RESULT
   
   

   Result	Proceed to
   P0630 is output	A
   P0630 and other DTCs are output	B

   If any DTCs other than P0630 are output, troubleshoot those DTCs first.

   NOTE:

   If P0630 is stored, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is input. If DTCs other than P0630 are set, check them first.

Result: 

B 

GO TO DTC CHART 

Refer to:

DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 10/2016]

DIAGNOSTIC TROUBLE CODE CHART [10/2016 - 08/2017]

DIAGNOSTIC TROUBLE CODE CHART [08/2017 - 08/2018]

Result: 

A 

See step  2

1. Refer to the REGISTRATION (Refer to REGISTRATION [08/2015 - 08/2018] ).

Result: 

NEXT 

END