DTC P060E: Internal Control Module Throttle Position Performance [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC
1. Clear DTC (Refer to DTC CHECK / CLEAR [08/2015 - 08/2018] ).
2. Turn the ignition switch off.
3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the ignition switch to ON.
6. Wait 16 seconds or more.
7. Check DTC.
  OK
  
  P060E is not output.
Result:

OK

CHECK FOR INTERMITTENT PROBLEMS

(Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2015 - 08/2018] )

Result:

NG

REPLACE ECM

(Refer to REMOVAL [08/2015 - 08/2018] )