Typical Enabling Conditions
WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
ALL (CASE 1 AND CASE 2)
| Monitor runs whenever following DTCs not stored | P2120, P2122, P2123, P2125, P2127, P2128, P2138 (Accelerator pedal position sensor) |
| Either of following conditions 1 or 2 met: | - |
| 1. Ignition switch | ON |
| 2. Throttle actuator power | ON |
CASE 2
| VPA2 voltage | Less than 4.84 V |
| Either of following conditions 1 or 2 met: | - |
| 1. VPA voltage - Learned VPA accelerator off position voltage | 0.04 V or more |
| 2. VPA2 voltage - Learned VPA2 accelerator off position voltage | 0.04 V or more |