Typical Enabling Conditions
WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
ALL:
| Monitor runs whenever following DTCs not stored | None |
| System guard* judge condition | ON |
| *: System guard is ON when the following conditions met | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor failure | Not detected |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or higher |
| Throttle actuator failure | Not detected |
P2111 (THROTTLE ACTUATOR STUCK OPEN):
| All of following conditions met | - |
| Throttle actuator current | 2 A or more |
| Duty cycle to close throttle | 80% or more |
P2112 (THROTTLE ACTUATOR STUCK CLOSED):
| All of following conditions met | - |
| Throttle actuator current | 2 A or more |
| Duty cycle to open throttle | 80% or more |