DTC P1604: Startability Malfunction [08/2017 - 08/2018]: Description

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

This DTC is stored when the engine does not start even though the STA signal is input or when the engine takes a long time to start, and when the engine speed is low or the engine stalls just after the engine starts.

Using the Techstream, the conditions present when the DTC was stored can be confirmed by referring to the freeze frame data. Freeze frame data records engine conditions when a malfunction occurs. This information can be useful when troubleshooting.

It is necessary to check if the vehicle ran out of fuel before performing troubleshooting, as this DTC is also stored when there is engine starting trouble due to running out of fuel.

DTC No.	DTC Detection Condition	Trouble Area
P1604	Either condition is met: The engine speed is below 500 RPM with the STA signal on for a certain amount of time (refer to the illustration below) (1 trip detection logic). After the engine starts (engine speed is 500 RPM or more), the engine speed drops to 200 RPM or less within approximately 2 seconds (1 trip detection logic).	Immobilizer system Engine assembly (excess friction, compression loss) Starter Crankshaft position sensor Engine coolant temperature sensor Fuel pump Fuel pump control system Fuel pipes Fuel injector Throttle body assembly Pressure regulator Battery Drive plate Spark plug Ignition coil circuit Intake system Camshaft timing oil control valve Mass air flow meter Air fuel ratio sensor Valve timing Fuel Purge VSV Intake valve Exhaust valve ECM