DTC P060B: Internal Control Module A/D Processing Performance [08/2015 - 08/2017]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC

Clear DTC (Refer to DTC CHECK / CLEAR [08/2015 - 08/2018] ).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Wait 16 seconds or more.

Check DTC.

RESULT

Result	Proceed to
DTC is not output	A
DTC P060B is output	B
DTC P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D are output	C

Result:

CHECK FOR INTERMITTENT PROBLEMS

(Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2015 - 08/2018] )

Result:

REPLACE ECM

(Refer to REMOVAL [08/2015 - 08/2018] )

Result:

GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D)

(Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input [08/2015 - 08/2017] )