LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Emission Control System (3UR-FBE) (Service Information)) >> Air Injection Driver >> Removal [08/2015 - 08/2018] >> Procedure

Removal [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY 
    GTY561833Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the 4 air injection control driver connectors.
    2. Remove the bolt and disconnect the ground cable.
      GTY610916Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the 2 wire harness clamps.
    4. Remove the 3 bolts and air injection control driver.
      GTY611209Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 1) 
    GTY611462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 bolts.
    2. Remove the 2 screws and air injection control driver.
      GTY610746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 2) 
    GTY132940Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 screws and air injection control driver.
scientia non olet · About LEMON Manuals