Installation [08/2015 - ]: Procedure

1. Set the fan and generator V belt onto every part.
   Fig 1: Engine Drive Belt Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. While turning the belt tensioner counterclockwise, remove the pin.
   NOTE:

   Make sure that the V belt is properly set to each pulley.

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   After installing the belt, check that it fits properly in the ribbed grooves.

   HINT: 

   Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

Refer to

PROCEDURE - Step 12 [08/2015 - 08/2019] , or refer to

PROCEDURE - Step 12 [08/2019 - 08/2021] , or refer to

PROCEDURE - Step 12 [08/2021 - ]

Refer to PROCEDURE - Step 16